1A1 Diamond Grinding Wheel 125mm D100 Anti-Glazing Self-Sharpening Design Carbide Grinding Optimized Bond Concentration

When a grinding wheel working face gradually becomes shiny or glazed, cutting ability drops, grinding efficiency falls, machine load or grinding resistance increases, the processing area heats up and the workpiece surface may discolor or burn, the wheel tends to clog and requires more frequent dressing, and increasing the feed rate no longer improves the grinding state, the wheel has lost its self-sharpening balance.

If dressing restores cutting ability only for a short time and the face glazes again soon after, the bond, self-sharpening behavior, grit size, concentration and chip clearance conditions should be checked against the actual working condition.

This 1A1 diamond grinding wheel 125mm D100 is engineered with an anti-glazing self-sharpening design. The bond hardness, grit concentration and chip clearance are matched to carbide grinding, so worn grains are shed at the right rate to expose fresh cutting edges, preventing face dulling, burn and excessive dressing cycles.